![]() ![]() ![]() Yes, I do! I make a lightweight steel frame/rack system that supports Ortlieb or AndyStrapz panniers. “does anyone produce frame/luggage rails to hold soft luggage off the exhaust?” Yes, the 4PT Acerbis tank will fit an earlier 3TB – but for a perfect fit, you’ll also need a 4PT seat, side panels & tail piece. ‘Trix’ asked: “Does the Acerbis tank fit the 93?” The 3TB was the only model without one.ģTB & 4PT Top yoke/ignition switch differentģTB & 4PT tank/seat/side panels/tail piece - different, but interchangeable as a complete set.ĤPT2 onwards uses an engine that has the old XTZ660 type clutch actuator mounted on the top of the clutch cover rather than using a pushrod actuated from the left, as all other XT550/600 models used.ģTB/4PT shock/linkage/swingarm/brake/rear wheel are essentially the same. (but uses the same twin piston 3TB caliper) The 3TB disc had 6mm fasteners – The 4PT, 8mm.ĤPT had a rev counter, as did all other XT550/600 models. Major differences, starting at the front.ĤPT had a larger diameter brake disc. **95/96 4PT1 model looks like a 4PT but uses the old 3TB engine with L/H/S clutch cable entry** The solution for me was to cut a small piece of plastic from the under part of the seatpost that in normal circunstances fit on the frame as it should!įor me, I cut it and made two hexagonal holes to fit some nuts and used two screws to lock the seatpost!Īs for the ACERBIS fuel tank, I don-t see why it won-t fit as long as you change the seatpost and bodywork as well. It was due to the fact that I welded a new rear shock mounting point to the frame as you can see in the next picture. but, the exhausts for those newer models will fit on the pre 1996 modelsīUT I suggest that you make a bracket of some sort to reinforce the frame from the exhaust mounting point to somewhere else in the upper frame of even the exhaust itself although I think I remember someone saying to me sometime ago they've done this without that bracket I mentioned.Was it you Wolfzero?Īs you can see, There appears to be a slight difference between the seatpost and the right side fairing. I've changed all my bodywork on my 1990 XT600E to the 2002-2003 Deep Purp.Blue and it all fits in the right places! even the pillion seatgrabs fit right!īUT, you will have to change the fuel tank, the seatpost, left and right plastics and the rear fender alltogether as they aren't compatible with the pre-96 models since they changed the bodywork!!Īs for the exhaust not being part of the frame structure after 1995 model you are right. Guys, changing the plastics is possible and there is no difference in the mounting points. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |